BSI公布EN71-8- 2011 - 立雍科技實業有限公司｜膠合棧板｜護角紙｜紙棧板｜木棧板｜塑膠棧板

跳至主要內容

Home
About Lion
Products
News
Certificates
- Patents
- Certificate of Analysis
Contact
Members

Home
About Lion
Products
News
Certificates
- Patents
- Certificate of Analysis
Contact
Members

English

English 繁體中文简体中文

Article classification

Environmental protection regulations
Global environmental current affairs
EU WEEE Directive and Current Affairs
EU RoHS Directives and Regulations
REACH related regulations and current affairs
European Union Standards Organization-EN13427~EN13432
European Chemical Agency (ECHA)
German two-way system DSD-green dot mark
EU Energy Use Products Directive
Environmental and ecological related reports
Articles
Pallet specifications by country

Environmental News>

BSI published EN71-8-2011

2012-01-05

The British Standards Institution (BSI) recently published a new standard, EN 71-8: 2011, for toys for home entertainment. This standard replaces EN 71-8: 2003 + A4: 2009 and will become an enforceable harmonized standard upon its publication in the Official Journal of the European Union. Compliance with this standard is considered equivalent to compliance with the relevant provisions of the new Toy Safety Directive 2009/48/EC. Furthermore, any conflicting national standards must be withdrawn no later than March 2012.

challenge:

Products such as wading pools, climbing frames, toy houses, and tents are now explicitly included in the scope of application of the new standard.
In the new standard, the load for stability and strength tests should be determined based on the number of users, the location of the load (swing, slide, or rope), and the area of the platform.
For family entertainment toys suitable for children aged 3 or older, the requirement for finger insertion has been revised to: if a test rod with a diameter of 7 mm can be inserted into any gap or hole in the toy, then a test rod with a diameter of 12 mm should also be inserted.
Swings – For swings intended for children aged 3 or older, or swings where the support is less than 1 meter above the ground, an impact test on the support and an evaluation of the support geometry are added. However, this impact test is not applicable to swings where the support weighs less than 1 kg, or to two-seater swings with fall arrest rails on three sides of the seat.

Slides – A new testing method has been added to evaluate the angle between the sliding section and the horizontal plane, as well as the angle between the sliding section and the bottom smooth section. The requirements are 60 degrees and 120-150 degrees respectively (depending on the height of the initial sliding section).
Wading pools – Swimming pools with a maximum depth of less than 0.4 meters are defined as wading pools. The new standard stipulates that wading pools should meet the relevant requirements of EN71-1 for inflatable toys. However, for wading pools with rigid outer perimeters, a strength test has been added, requiring these pools to not only meet the requirements of EN71-1 but also to meet corresponding strength requirements.

Source: Intertek

上一頁PreviousMonoma County, Oregon's most populous county, passed a BPA ban.

NextEU revises bicycle safety standards下一篇

Line

Lion Technology Industrial Co., Ltd.

Phone: +886-2-26793552
FAX: +886-2-26794698
Email: Service@Li-On.Biz

Head Office/Factory Address: No. 161, Jianshan Road, Yingge District, New Taipei City 23942
No. 161, Jianshan Rd., Yingge Dist., New Taipei City
23942, Taiwan (ROC)

Welcome! You are the visitors

© 2026 LION Green Design Co., Ltd. All Rights Reserved